This Zenitel IP speaker features a 10W Class D amplifier, powered over PoE. This means that the speaker is capable of delivering more than 120dB, depending on the signal input. The Long Horn Variant increases SPL and directivity. This speaker is best used in environments where speakers must be placed at distance from the intended  listener, and installation space is less of a concern.
With IP, the system is able to monitor and address each speaker individually. By moving the amplifier from a central unit out to the speaker itself, the need for a central amplifier unit with conventional speaker loops is eliminated. This makes the system highly scalable, and adding another speaker is easy to do.
Whilst conventional speaker loops are not used, the speakers can still be divided into groups. These zones can now extend over networks or span the Internet.  To provide maximum availability, the speaker comes with advanced supervision functions.
The built-in microphone enables intelligent features such as Self-checking, and Automatic Volume Control. It also enhances what is traditionally a broadcast-only medium adding Half Duplex speech, and Ambient Listen functions. Self-checking will detect whether there are any faults in the network or speaker electronics. The status of the speaker is reported to the central unit as well as to 3rd-party management systems using SNMP or Syslog. The speakers can also be discovered, receive messages, and use Talkback direct to a VMS over ONVIF.
The speaker has a built-in web interface for status information, control, and upgrade. It is easy to install and maintain. In addition, there are possibilities where broadcasts can be logged in detailed reports.
GENERAL | |
---|---|
Max. sound pressure level at 1 meter | 120 dB |
Max. sound pressure level at 200 meter | 74 dB |
Dispersion (-6dB) 1kHz / 4kHz | 81° / 37° |
Directivity factor, Q | 4,5/9,6 |
Codecs | G.711, G.722 |
Frequency range, G.722 Codec | 200 Hz – 7000 Hz |
Frequency range (speaker driver) | 290-8000 Hz |
Internal speaker amplifier | 10 W class D |
Mounting | Bracket (included) supporting pole and wall mounting |
Material / Color | ASA (plastic) / RAL 7035 (light grey) |
Electronics cover material | ASA (plastic) |
Gasket material | Silicone rubber |
IP Rating | IP66, tested according to EN 60529 |
ENVIRONMENT AND COMPLIANCES | |
---|---|
Operating temperature range | -40° to 70° C / -40° to 158 ° F |
Storage temperature range | -40° to 70° C / -40° to 158 ° F |
Relative humidity | < 95% not condensing |
EMC | CE and FCC Part 15 |
HARDWARE | |
---|---|
Ethernet connector | 1 x RJ 45 |
All other connectors | Tool less, spring loaded, vibration proof terminals |
General inputs and outputs | 6 (configurable) |
Outputs | 12mA as LED drivers |
Power options | PoE |
PoE (power over Ethernet) | IEEE 802.3af standard, Class 0 (0.44W to 12.95 W) |
Power consumption | Idle 1.8W, max 12W (depending on volume) |
Audio line out / induction loop signal | 600 Ohm |
NETWORKING AND PROTOCOLS | |
---|---|
Protocols | IPv4 (with DiffServ), SIP, TCP, UDP, Unicast, Multicast, HTTPS, TFTP, FTP, RTP, DHCP, SNMPv2c, ONVIF, CCoIP® , NTP |
LAN protocols | Power over Ethernet (IEEE 802.3 a-f) Network Access Control (IEEE 802.1x) |
Management and operation | HTTP/HTTPS (Web configuration) DHCP and static IP + IC-EDGE. Remote automatic software upgrade. Centralized monitoring |
Advanced supervision functions | E.g. network test, tone test, status reports, uptime |
SIP support | RFC 3261 (SIP base standard), RFC 3515 (SIP refer), RFC 2976 (SIP info), Multicast streaming |
DTMF support | RFC 2833, 2976 (SIP info) |
OTHER SPECIFICATIONS | |
---|---|
IP address information | Speaks IP address after system boot |
Country of manufacture | Poland |
Dimensions (HxWxD) | 274 x 200 x 348 mm |
Weight | 1.9 kg / 4 lbs |
Encapsulation material | ASA plastic |
DIN-rail clips | Wago 209 (included) |
Boxed weight | 2.25Kg |
Boxed Dimensions (WxHxD) | 280 x 250 x 400 mm |
STENTOFON Communications Australia Pty Ltd
670 Mountain Highway, Bayswater VIC 3153, Australia
Phone: +61 3 9729 6600
Fax: 03 9729 0099
Postal Address:
PO Box 1095
Bayswater Business Centre
AU-Bayswater VIC 3153
Australia